TE Technology - TE Technology

Liquid Reservoir

TE Technology // Free Thermoelectric Design Service // Liquid Reservoir
Liquid Reservoir - Fill in your specifications and submit your design to TE Technology.
To see the detailed drawing of this configuration, please click the graphic.

(Adobe Flash Player is required to use this Design Service, but only download the player if a grid does not display in Range of Typical Parameters below.)

Design Specifications
		Warmest External Temperature:
		Highest External Humidity:	`%`
		Lowest Desired Cool Liquid Temperature:
		Internal Width:
		Internal Height:
		Internal Depth:
		Insulation Thickness:
		Insulation is much less expensive than the additional cost in thermoelectrics! Always use the maximum amount of insulation possible. Do not include the thickness of structural components such as steel or plastic.
		Heat generated inside the enclosure: Waste heat from electronic equipment, lights, chemical reactions, etc.

Design Calculations
		Insulation Loss:
		Total Heat Load:
		Exterior Wall Temperature:
		Interior Wall Temperature:
		Ambient Dew Point:

Standard Product Recommendation
TE Technology's analysis assumes the insulation is extruded polystyrene foam and no solar heat load is present. We have not included additional heat losses through doors, windows or gaskets. If your enclosure has these features please tell us in the comment section and send us an email as additional capacity will be needed to compensate for these losses. Note: water is assumed to be flowing at 1.6 L/min. Different flow rates or different fluids will affect performance.
Range of Typical Parameters for a Custom-Designed System



		Hot Exchanger Temperature:
		Cold Exchanger Temperature:
		TE Input Power:
		System Size:


(Download the Flash Player only if a grid does not display above.)
Contact Information
If you require additional information not provided in this online design service, please enter your contact information below and a TE Technology representative will contact you. Email Privacy Policy We will use your email address only for the purpose of sending you the summary report from our design service. It will not be added to a mailing list or used for any other purpose. We will never share, sell, or rent individual personal information with anyone.
E-mail Address:
Your Name:
Company Name:
Address:
Address2:
City, State/Province:
Zip/Postal Code:
Country:
Phone #:
Fax #:
Comments: Please provide as much detail as possible in the comments field to maximize the effectiveness of our response.
	This report will include all of the information presented to you above plus additional analysis, cautions, and recommendations too lengthy to present over the internet. (Only E-mail Address is required for this.) This will send a copy of the summary report to you and to a TE Technology engineer so that we can discuss your application further. (Required fields are indicated in bold.)

Disclaimer: The suggestions provided in the design analysis are only estimations based the limited data submitted by you and do not take into consideration many other relevant factors. It is the responsibility of the customer to verify the design analysis and test the product in the desired application. TE Technology, Inc. has made no promises with regard to the design analysis. TE Technology, Inc. disclaims all warranties in connection with the design analysis, express or implied, as to any matter whatsoever, including without limitation description, quality, design, performance, specifications, condition, merchantability, and fitness for any particular purpose.